Nurage was modeled after a modded version of the most famous Low Pass Gate. Nurage comprises Vult’s own (very detailed) model of the vactrol control and the filter.
This module can be used to produce very natural sounding percussion sounds. It provides the possibility to enable or disable the Vactrol, the VCA and the possibility of using the module as stereo filter.
The Cutoff, Resonance and Drive knobs affect both filters. Each of these knobs provides an attenuverter and input jack for modulation.
Gate (Jacks): these inputs, in addition to the dedicated CV input, control the cutoff frequency of the filters. The main difference with the CV input is that the attenuverter of the gates has amplification. This makes possible to increase the range of gate signals with low level. Depending on the Gates mode switch, the Gate signals can control both or each filter separately.
Vactrol (Switch): enables and disables the Vactrol control of the gate. With the Vactrol ON, the filter presents smoother transitions due to the Vactrol memory effect. With the Vactrol OFF, the controls signals immediately affect the Cutoff.
VCA (Switch): Enables of disables the VCA mode. In VCA mode, the filter not only changes the cutoff frequency but also affects the amplitude of the signal. One thing to notice is that by enabling the VCA mode the resonance of the filter is extremely reduced.
Gates (Switch): defined the behavior of the gates. In Link mode, both gates control both filters. In Unlink mode, the left Gate control the Left filter and the right the Right filter.
Nurage is a dual or stereo filter. It provides pairs of left and right inputs and outputs in order to simplify processing stereo signals.
Help improve this manual here.